ユーザ名 パスワード   → パスワード紛失 → 新規登録

投稿数ランキング

1 wangkiky 10629
2 valakaz 9856
3 huangbao1 929
4 lw789 900
5 Meeniwo 646

攻略チャート

攻略支援情報

データベース

装備データ

オンライン状況

32 人のユーザが現在オンラインです。 (9 人のユーザが フォーラム を参照しています。)

登録ユーザ: 2
ゲスト: 30

avyhuze, drugplace7, もっと...


FF12RW情報提供 : Working Principle of Hand Oil Pump

投稿者 トピック
wangkiky
  • 登録日: 2016-1-8
  • 居住地:
  • 投稿: 10629
Working Principle of Hand Oil Pump
The reciprocating motion of the plunger in the plunger sleeve completes the oil suction and pressure of the fuel injection pump. When the plunger is located in the lower part, the two oil holes on the plunger sleeve are opened, the inner cavity of the plunger sleeve is connected with the oil passage in the pump body, and the fuel is quickly filled into the oil chamber.
When the cam is crowned on the roller of the roller body, the plunger rises. From the beginning of the plunger upward movement until the oil hole is blocked by the upper end of the plunger. During this period, due to the movement of the plunger, the fuel is squeezed out of the oil chamber and flows to the oil channel. So this lift is called a pre-trip. When the plunger blocks the oil hole, the oil pressure process begins. When the plunger goes up, the oil pressure in the oil chamber rises sharply. When the pressure exceeds the spring elasticity and the upper oil pressure of the oil outlet valve, the oil outlet valve is jacked out and the fuel is pressed into the fuel pipe and sent to the injector.
The time when the oil inlet hole on the plunger sleeve is completely blocked by the upper end face of the plunger is called the starting point of theoretical oil supply.
When the plunger continues to move upward, the oil supply also continues. The oil pressure process lasts until the helical inclined edge of the plunger lets the plunger sleeve return to the oil hole. When the oil hole is opened, the high-pressure oil flows back to the oil channel of the pump through the longitudinal groove on the plunger and the oil return hole on the plunger sleeve. At this time, the oil pressure of the plunger sleeve chamber decreases rapidly, and the oil outlet valve falls back to the valve seat under the action of the oil pressure in the spring and high-pressure tubing. The injector immediately stops injecting oil. At this time, although the plunger continued to ascend, but the oil supply has been terminated.
The time when the upper return hole of the plunger sleeve is opened by the oblique side of the plunger is called the theoretical oil supply terminal point.
From the above process of oil absorption and pressure, it can be seen that in the whole process of plunger upward movement, only the middle stroke is the process of oil pressure, which is called the effective stroke of plunger.
read more:

Lever Action Drum Dispenser pumps
High efficiency WP20 2 Inch Agricultural Gasoline Water pumps
Mini Air Vacuum Pump Korea
vacuum atmosphere chamber furnace 1400 degree


FF12レヴァナント・ウイングは(株)SQUARE ENIXの登録商標、もしくは商標です。
Copyright © 2007 ff12rw.hocolamogg.com, All Rights Reserved.